Hey everyone,
I am currently recalibrating my printer after.not using it for a while. When doing a flow test I noticed these blobs forming in the middle of the circles.
AFAIK these are often caused by moistures in the filament. I already dried the filament at 50°C for a couple hours in the oven and the problem persists. So I guess I should simply get rid of the filament and open a new pack?
What’s your assessment?
If you have a PTFE lined hotend, this kind of blobbing can also be caused by bowden gap IIRC. Might be easier to provide suggestions and ideas if you added some information about what printer you have, what filament it is, and what your other slicer settings are.
https://feddit.org/comment/9055184