There are a lot of ways to go. My own isn’t particularly efficient, but it’s an old rack mount server. Everything is built like a tank. It’s robust as hell, and yet everything was well used and cheap. Probably not a good solution if you live somewhere with expensive power, but I don’t.
I’ve been hosting Emby forever (and the requisite software to acquire content 😉).
Recently I added Nextcloud to facilitate cutting several Google products out of my life. Combined with a few FOSS apps, it’s currently doing the job of Drive (storage) and Keep (notes), and I’m planning to move my contacts and calendar this week.
Yeah, mostly because of the entire tech industry for the last decade. I’ve gad every ounce of trust incinerated.
Oh, I think they’re communicating just fine. They’re signalling the direction they plan to take and it’s not a good one.
Not as drastic as I had hoped, but it looks like around 5% better layer adhesion provided you increase the flow rate slightly to fit in the gaps. It essentially makes a print that’s more solid in the walls.
I saw elsewhere someone doing prints with transparent filament and they were also getting optically better prints with this.
Also, there’s a pull request on Orca… Not sure when it’ll come out, but they’re working on building it into the slicer.
They have showed their hand. i would be VERY unlikely to extend my trust to Bambu again. To be clear, I don’t necessarily regret my purchase of an X1C, but I’m now running in “local” mode with my machine blocked from WAN access and I don’t intend to let Bambu back in.